Step 1:
Click on "File" at the upper left corner of the OutLook main page.
Step 2:
Click on "Account Settings".
Step 3:
Click on "New..." on the next popped up window.
Step 4:
Seletc the option with "Manual setup or additional server types" on the next popped up window and then click "Next".
Step 5:
Select the option with "POP or IMAP" and click "Next".
Step 6:
Fill out the User Information, Server Information (in Account type select "IMAP" from the drop down list) and Logon Information (In Password Box, type the same password which you have for (Your Email Address) test@domain.net then click on "More Settings".
Step 7:
Click on "General" and see that your email address is listed there (Don't do anything here).
Step 8:
Click on "Outgoing Server" and make sure to select the check box with "My outgoing server (SMTP) requires authentication and the select the option with "Use same settings as my incoming mail server".
Step 9:
Click on "Advanced" and fill out Server Port Numbers as follows (incoming server (IMAP: 143) and outgoing server (SMTP: 2525)) and make sure to select the check box with "Purge items when switching floders while online" mentioned below the window. and then click "OK".
Step 10:
Click "Next on the following window.
Step 11:
Process got successful, now press "Close".
Step 12:
Click "Finish" on the following window.
Step 13:
Close this window too.
Step 14:
Now you can see at the left side of the OutLook main page that email is now configured.
Step 15:
You may see the process after sending an email by clicking on Send/Receive all Folders on the upper left corner of the OutLook main page.
To Repair an Existing Account
On step no. 3, click on "Repair..." instead of "New..." and repeat the same procedure from step 4 to step 15.
Both sebding and receiving are now successful.
How to Configure Email Account (or Multiple Email Accounts) in OutLook and How to Repair an Existing Account.
- 150 Users Found This Useful
Related Articles
Powered by WHMCompleteSolution
